Hi,
My lab got a GiDEL board recently, and I'm trying to run the EdgeDetect program provided in ImpulseC examples on it. I opened the project, generated both Hardware and Software files after I changed the project setting to "PROCWizard(VHDL)", and got the .pcaf file(I believe it's used by PROCWizard) in /hw folder along with some VHDL files. Also I got 2 C files(co_init.c, edgedetect_sw.c) and a header file(edgedetect.h) in /sw folder. What's the next step?
I'm new to GiDEL as well as Impulse C, so any advice/suggestion will be greatly appreciated. Thanks
0
Next step?
Started by The.Soloist, Jun 29 2009 01:18 PM
2 replies to this topic
#2
-
- Admin
-
- 348 posts
Advanced Member
Posted 30 June 2009 - 05:38 PM
Improvements to the GiDEL PSP are in development in concert with the University of Florida's CHREC lab. I can send you an updated PSP and some documentation this week via personal message on this forum.
Which board are you using?
Which board are you using?
Ralph Bodenner
Impulse Accelerated Technologies, Inc.
Impulse Accelerated Technologies, Inc.
#3
-
- Members
-
- 7 posts
Member
Posted 30 June 2009 - 08:18 PM
QUOTE (RalphBodenner @ Jun 30 2009, 09:38 PM) <{POST_SNAPBACK}>
Improvements to the GiDEL PSP are in development in concert with the University of Florida's CHREC lab. I can send you an updated PSP and some documentation this week via personal message on this forum.
Which board are you using?
Which board are you using?
Thanks for the reply. The PSP and doc will be really appreciated
We're using GiDEL's PROCeIII board with Altera's stratix III EP3S260 FPGA.
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users
